Basic Tips on Repairing Your Air-conditioner – Common Issues and Calling Experts


There are certain simple steps you can take to begin repairing your aircon. If you want to do the job right, it is important that you follow these guidelines so that you don’t waste any time or money on mistakes. The first thing you will want to do is to turn off the power to your aircon and unplug it from the wall.

This is very important because otherwise, the electronics could melt the wires and other parts of the system. The next step you should take is to disconnect the power wires from the aircon system. You may need to use an adjustable wrench or special icon pliers for this job.

Be careful to keep all wires away from any magnets or staples used to fasten the unit together. You should also make sure that the screws in the aircon are not stripped. It is possible to ruin a unit by stripping the screws, especially if you have taken it apart.

After you have done this, you will need to disconnect the compressor hose. There are two reasons why this may be needed. First, some air conditioners use a choke tube that carries a constant water supply to the compressor. These constant water feeds cause the compressor to work harder to cool the air.

When the compressor is working harder, it generates more heat, which causes the compressor fan to work even harder. If you drain the water feed and let the fan run, you may damage the fan instead of cooling the air. Now, you must remove the screws from the aircon system.

This reliable air conditioning contractor in Puchong is renowned for their quick, effective, and affordable services. Be sure you set aside the time to check out their website to find out more about them.

Start by unscrewing the bolts holding the aircon to the frame. You may have to use a screwdriver or pry bar in order to remove as many screws as possible without damaging anything. Once you have removed the main body of the icon, you will notice that the compressor hose is free and hanging.

You may need to use pliers to remove the couplings that are holding the other pipes. After you have removed the hose, you will need to find the wiring already attached to the house. This way you will not have to start wiring everything from scratch.

Some of the things that may need to be reattached are the wires to the light switch and ceiling fan. There are usually three wires, but some manufacturers make additional wires for their HVAC systems. If there are multiple wires, you will need to figure out how to connect them.

The most common way is to use electrical tape to hold them in place while attaching them. Once you have successfully attached the wires, you should install a fuse to ground yourself from the ground to the house. Once you have the wires in place, you will need to reconnect the fan blades and ceiling fan blades.

If you are doing the repair on the older system, you may have to remove the old blade to access the wires. The newer systems are easier because all you have to do is attach the new blade and screw it in. Take your time with this process to ensure you have fixed the problem correctly.

Once you have all of the parts in place and the screws fixed, you can start testing to see if your aircon works correctly. Start by opening up the aircon to room temperature and setting it inside. If the unit cools off quickly and easily, it is working properly. It may take a few tries before you get the hang of this.

If the unit becomes very hot, it could mean that you need to check the other components. Most times, the problem is with one of the aircon units, so you will just have to repair that component and the entire thing should be working again.